Perma-Liner Industries India Pvt. Ltd.

03 · Pressure and drinking water · T-06

Spray-in-place pipe (SIPP)

Spray-applied structural coatings for pressure and potable pipes.

Pipe interior after spray-in-place lining, back in service. Illustrative image.
Pipe interior after spray-in-place lining, back in service. Illustrative image.
Diameter range
DN100 to DN3000
Material
Polymer, epoxy or polyurea
Application
Centrifugal or spray
Standards
AWWA C620 · NSF/ANSI 61

Overview

A structural polymer coating is applied centrifugally or by spray, conforming to the pipe's existing bore with little loss of flow area. It suits complex geometry, bends and large pipes where inversion is impractical.

Drinking-water-approved formulations allow use in potable and process-critical pipelines. We select the coating system and thickness for each project.

Inside a pipe after spray-in-place lining, looking back towards the spray equipment at the access point.
Inside a pipe after spray-in-place lining, looking back towards the spray equipment at the access point.

How it works

  1. 01

    Clean

    Pipe descaled and dried to the coating specification.

  2. 02

    Apply

    Coating spun or sprayed to the design thickness.

  3. 03

    Cure

    Coating cured and thickness checked.

  4. 04

    Test

    Adhesion, holiday and pressure testing.

Applications

  • Corroded water mains
  • Pipes with bends and fittings
  • Large man-entry pipes
  • Process and cooling water lines